I see “Inlay Female” and “Inlay Male” in operations when I look at video about Millmage.
Why isn’t available in my just bought version?
If I recall correctly, that feature was temporarily withdrawn to be reworked.
But will be reintroduced once this work has been done
3 Likes
This is correct.
Because nearly everyone who tried them thought they were going to produce either V-carved inlays or a male “plug” pocketed with an area cleared around it. Ours does neither - the male inlay is a full-depth profile cut, and we need to clean up the documentation a bit to reinforce this to make sure people understand how it works, and how it might be different than other software they’ve used.
Basically, we don’t want to overwhelm support with questions from people who didn’t read the instructions. 
1 Like