Hello. I have a OMG-X 30w fiber laser running BJJCZ / Laser Mark Control Board v2. Currently set up from manufacturer to run Ezcad 2 and was wondering if there’s a way to get this working with Lightburn. I downloaded a trial and the usb search didn’t find my device and it’s not in the list of lasers. Any help would be appreciated.
I’m running an OMG-X 60w with the same board, and working fine here. Have you gone through the install documentation?
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.