With my Sculpfun S9 after updating to v1.7.04 will not fire when it should engrave but will when it is to cut and frame, please help me.
Post a .lbrn2 project file where this happens for us to check.
1 Like
Santa Mail Box.lbrn2 (238.1 KB)
I just noticed when the module goes to engrave the power to the module cuts out.
I just tried ungrouping the engrave layer to see what might happen, then it worked perfectly so i re-grouped it and it worked as well.
thank you for your time.
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.