Dual Laser and Image Quality

[tantrim (austen)]

It seems if you run the diode in RF tube mode it should just work?

Diode laser stays on while position moves

Gnd and Low? The laser connections on my Ruida controller are Gnd, L-On1 (laser on), and LPWM. The PWM output will be ramped up prior to firing, which is toggled by L-On1. You might need to change the tube type in the Machine Settings to be an RF tube without pre-inition instead of glass, as I think they just use the PWM output without the L-On signal, but I’m not certain. I’ve never used a diode laser with a Ruida before.