I’m hoping some one can help me out. I have spent countless hours trying to figure this out with no luck. I have been trying to run a “fill” design on my ruida 644xs with various results. Several times it has printed fine but most of the times it has cramed the last bit of design into a smaller area than intended. I have attached pictures below. I have reset everything, power cycles, defaulted machine settings and reapplied. Checked position of the different axis. I just can’t figure it out. I did also have 1 time of 10 that it mashed the start of the design and than printed the rest correctly.
Machine
RabitLaser 600x400 50 watt CO2 Ruida 644xs Controller
Roller style rotary
Lightburn 1.0.02
