Hi Oz, neither could I and I looked all over, I did find a PDF giving some details, see list of specs below if useful!
The software supplied with the laser was APS Ethos, this seems to be embroidery software. The original settings for cutting using this software were set to Velocity (!) 50 - Max power 50 - Min power 50 at 4 passes but I was told that more passes were needed for my leather on the original job.
Tonight I had one of the original crew from my previous visits and we used these settings in Lightburn to get some good results.
Engraving - Speed 300 - power max 40 - power min 10
Cutting - All settings 50, but this required 4 sets of 5 passes
I don’t think there is another way to cut leather except lots of passes. Fortunately we have a supply of release paper to minimise flare. We may have to do more tests to find the sweet spot between settings to try and get number of passes down but I think that’s the best we can do with this laser probably?
The laser is 30 watt, here are the specs from the brochure.
Maximum Linear Cutting/ Engraving Speed
400mm / second.
Maximum Raster Image Engraving Speed
666mm / second.
Resolution Ratio
0.0064mm.
Minimum shaping character: Letter: 1 x 1 mm
Location precision: <0.01 mm
Supported formats: .PLT, .BMP, .DXF, .Al, .DST, .DWG, .LAS
Power supply: ACl 10 to 220V±l 0%, 50/60Hz
Power Consumption< 1250 Watts at maximum.
