Engraving lines square but image distorted?

[JohnJohn (John Johnson)]

Does it look like this:

How do I fix skewed or slanted engraving?

This is an example of a fill followed by a cut around the letter A: [image] The fill is slanted, but the cut appears to be correct. If you have engraving that is slanting to one side, but cuts appear correctly, you likely have your motor pulse step polarity set incorrectly. On Ruida controllers, there’s a setting called ‘PWM Rising Edge Valid’ that you can change for each axis that tells the controller whether the rising edge or falling edge of a step pulse is what the motor driver is lookin…

Either way, Feel free to attach a pic of what’s happening in a reply.
Screen captures are helpful and welcome too.