Erro GPIO isr handler remove

LightBurn Hardware Compatibility TwoTrees
1

Aparecendo o erro abaixo, o laser funciona em determinados momentos, mais as vezes para do nada e em outros momentos nem inicia. Preciso de ajuda. Uso TTS 55 e lightburn

E (353620) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (353621) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (353631) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
Grbl 1.1h [‘$’ for help]
ok
ok
A iniciar transmissão
Layer C00
[MSG:Restoring spindle]
[MSG:Program End]
Transmissão concluída em 0:16
E (371564) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (371565) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (371575) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
Grbl 1.1h [‘$’ for help]
ok
ok
E (371602) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (371603) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (371613) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
Grbl 1.1h [‘$’ for help]
ok
ok
Hold:0|MPos:0.000,0.000,0.000|WPos:0.000,0.000,0.000|FS:0,0|Pn:P|Ov:100,25,100|A:M

2

When the error shown below appears, the laser works at certain times, but sometimes stops out of nowhere, and at other times, it won’t even start. I need help. I am using a TTS 55 and LightBurn.

This indicates you successfully connected. The repeating errors, and your statement below suggests you have a USB communications issue.

  1. Try replacing the USB cable. It is best to use a quality one that is shielded and has a ferrite (big lump or knot) on it.
  2. Check for a loose USB cable connection on the PC end or the laser end.
  3. Make sure the USB cable extends no more than 10 feet (3 meters).
3

Já fiz isso, nada resolve. Agora configurei para rede eu fiz e continua parando no meio da gravação.

4

Reduce both the power and speed some to see if it will run longer before it stops.