Error:1 Software error

[Niko91 (Niko)]

Hej, I start the engraving and after a few second the stops (than I tipping “$” in the console), and this showing up(translated from German to English with googlee translate ):

Stream is started
layers C00
error:1
G code words consist of a letter and a value. The letter was not found.
On or near Line 61:
job stopped
Stream completed at 0:00
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
$
[HLP:$$ $+ $# $S $L $G $I $N $x=val $Nx=line $J=line $SLP $C $X $H $F $E=err ~ ! ? ctrl-x]
OK

Thanks

[berainlb (PY)]

Click Devices button in Laser window. Does it show your laser configured as a iLaser device? If so, push Edit and change to GRBL. Then click next until done.

Retest.