Using an Aufero Laser 2.
I have a project that when I run on my PC, it goes just fine. When I do it on my Mac, it runs for roughly 30-45 seconds, then fails.
I get…
error:2
Numeric value format is not valid or missing an expected value.
On or near line 0:
Job halted
Stream completed in 0:00
Other projects I have no issue with, I originally did this in illustrator then imported. Later I retraced it by hand in lightburn. Same result.
Where am i going wrong? Is this an accelerometer issue?
I run $X to turn off alarms before I start my project .
ray 3.lbrn2 (37.3 KB)