Error after update Lightburn

[suko]

Hello,

After I updated Lightburn to 1.0.02 I keep getting error 9.
Not sure what to do at this point. First time ever I received an error and it happened right after the update for me. I print on an Ortur LM2 inside a ventilated enclosure.

full message;
Ortur Laser Master 2 Ready!

OLF 140.

Grbl 1.1h [’$’ for help]

[MSG:’$H’|’$X’ to unlock]

error:9

G-code locked out during alarm or jog state.

On or near line 33627:

Job halted

Stream completed in 35:28

[Ashkan4818 (Ashkan)]

Did you enable auto-home on startup in Lightburn?In this case, disable it or disable home in GRBL settings and see if you still see this error,

[suko]

Thanks, disabled auto-home and everything is fine again.