Factory installed CCD camera system and RDC6442G-DFM-RD / Lightburn support

LightBurn Hardware Compatibility Ruida controllers
1

Hello from Finland. This is my first post here. I tried to use search about the subject but didn’t find too much information.

I am receiving my 2 laser cutters from China after one week and bigger one has factory installed CCD system. I would like to use Lightburn with the factory installed camera setup. If I understood correctly Lightburn does not support factory camera setups yet(?). Is there any new information?

This is my first time owning a laser machines so all the information is really appreciated.

Thank you!

Best regards
Ilkka

1 Like
2

LightBurn does not currently support the factory CCD setups, no. Supporting the controller is relatively easy, but the CCD and corresponding features haven’t been investigated yet, so it will be quite a while before those are supported.