Factory setting

can you set back to a factory setting with lightburn?
because my laser no longer lasers. Or rather he lasers yes, but you don’t see any result, even if you put at full capacity. Does anyone have any advice

We need to know what you mean when you say “my laser”. The listing in your forum profile is not a laser / motion control system we are aware of. :wink:

This should help in understand what we need and why.

I own an Ortur Master 2, I think it depends on the program.
because I bought a new Neje Master 2. With the Neje program, however, it does not work with Lightburn. But the program recognizes lasers.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.