When engraving image by default Lightburn starts scanning from the bottom regardless of where I position Job origin. I understand this is done to help with smoke extraction, however when engraving on a rotary this creates a problem. It spins object fast (controlled by acceleration setting) to it’s “bottom position” before starting engraving that it flies of the rotary attachment or looses alignment, etc. It took me some time to figure out that Scan Angle can be changed to 180 to prevent this, but maybe it can be automatically set 180 when “Rotary Enable” is ticked? 
There’s no reason to start from the “bottom” when engraving cylindrical object…
New features and product behavior suggestions can be presented on our site used to track these requests.
Ah thanks! I’ll do that!
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.