Hi All,
Was trying to dial in an engraved logo on copper in Lightburn ( Have not updated to 1.7 yet ) I am on a new Mac Did it 3 times with the same results. Machine started engraving from the bottom up ( An Aurora Lite 50 watt ) perfectly fine, then about 33% up it just barely marked the rest of it. Just for the heck of it I switched to an aluminum round blank and it completed the entire logo. Nothing was changed, power, speed, line interval , frequency etc. all the same for both.
I have no idea what is going wrong. Help would be very much appreciated.
Thank you,
Jim