Fill with Texture?

I’d like to burn a round band around an image, but I’d like it to be textured rather than just a solid bar.

E.g. - Outer line (not a cut) of a circle is 100mm and inner line (not a cut) of a circle is 90mm. In between those two lines, I’d like a texture of my choosing to appear.

I have some textured backgrounds. I suppose I could create a graphic of a “textured ring” as a graphic to import, but I just wondered if it was possible to get the desired effect in LightBurn itself.

You could also import an image and use a MASK so just the circle center is engraved

I know is possible, but would have to work out the steps to explain how.

1 Like

Like this maybe?

End result

Of course then you can set the circles to No OUTPUT Or use the circles to trace


Much appreciated. LightBurn (i.e., its developers) never ceases to amaze me – as well as folks like yourself who understand all the nooks and crannies. I can’t wait until the LightBurn conference this October!

1 Like

I will be there :slight_smile:

I knew it was a tool but i am honest i never used it myself!

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.