shovelhead
(Dave Bodkin)
1
Ortur master pro 2. Can’t cut at all I get a flame detector error I’ve used console command $261=0. Still fails immediately with this error.
Laser Machine : Ortur Max Pro 2 with current firmware LM2-4 system just assembled
Lightburn 1.0.0.4
There is no flames since the laser doesn’t fire, I’m in my garage I’ve tried low light and even lights totally out. No changes at all….
jkwilborn
(Jack Wilborn)
2
Search the forum. I had a bunch of hits on that topic. Should read through some of the threads about it.
There is an Outur section on this forum.
shovelhead
(Dave Bodkin)
3
FW v1.72 resolved my issues.
2 Likes
system
(system)
Closed
4
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.