I am pretty sure this has been brought up since the 2.0 update. I had heard mention that 2.0.02 had addressed this and fixed it. But I am still having problems.
If I am using the laser, (Roly MK2 XW), and the job finishes. If I power the laser off so the fan isn’t running and when I am ready to use the laser again and power it back on, Lightburn cannot communicate with the laser. I have to do a reset by right clicking on the devices button.
Then the laser rehomes and is ready to go to work. If you thought it had been corrected… I am still having the issue.