Hello all, I am new to using a rotary tool. I understand that these things are difficult to setup for the first time based on all the forum results. I ran though testing and found the steps per rotation is 6100. The circumference of my object is 11.24690 inches. When I try to line out a rectangle o…

Something you need to look at. What is the Y position on your controller? If your Y position does not make sense to the controller when you send your file you will get this error. What I mean is if your Y position reads near 0 and your origin in lightburn is near 500 with the graphic going towards 0…

LightBurn Software Forum

Frame Slop Error on Rudia

LightBurn Software Questions

rotary, omtech

← previous page

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled