Full Spectrum Laser RDC6445G-MOD5 Conversion Home Issue

[ednisley]

@Crispy001

Do you have visibility

Not from my Comfy Chair. I’m a civilian with no connection to LightBurn other than being a customer.

@Crispy001

relying on the controller

Opinion: Given the undocumented / reverse engineered nature of the whole DSP controller thing, I’m reasonably sure this is a case of “it’s worked on everything so far, but this one is different”.

As in, the KT332N controller in my machine responds differently than a KT332NZ in somebody else’s machine:

Monport Onyx R ; Z seemingly switched with U axis

This thing has a Ruida KT322NZ controller. Everything works for the most part, and this is somewhat of an oddity, which I think might be a bug in lightburn (or rather, a workaround for a different laser not applicable to the onyx R, but which can’t be disabled, as far as i can tell) In the ‘Move’ window, the reported Z position is actually the U axis position. The U axis position shown in the move window is 0.0 (which is fine, there is no U axis in this machine). The Z axis position shown in…

So, yeah, anything is possible.

@Crispy001

a little concerned that the unit of measure affects the homing behavior

That looks like an error from here, but I have no clue where it might take place.

@LightBurn: What further info would be helpful?