G-code motion target exceeds machine travel on Genmitsu 3180 PROVER

[berainlb (PY)]

I’ll refer you to another topic that may be of value. The title doesn’t match but it’s likely still relevant.

New to all this and ned help - a few questions

First off I suggest you read through these 2 topics thoroughly and make sure have a good grasp of what’s there. Common Grbl Setups - LightBurn Software Documentation Before making any changes, I highly suggest you take a backup of your machine settings. This should address your first 2 questions. As for the 3rd I’m not quite following what you’re describing but I suspect you’re struggling with panning operations. Check this link for that: Zooming, Panning, Selection - LightBurn Software Docu…