When trying to engrave images with the chuck rotary on the 30w Fiber Laser the engraving will start, about 1/3 of the way stop, rotate to a different position and then continue the rest of the engraving. Does this happen to anyone else?
Post a screenshot of the parameter layer screen, rotary framing screen, and rotary run screen. May be “Run whole shapes, if possible”, may be something else.
1 Like
Hi Denise… welcome to the forum…
I wish I had an answer… I had the same thing happen to me engraving a lens tube for the co2… It was doing fine, then rotated the other direction and did the final operation there…
I’m sure it’s in the artwork somewhere/somehow… I wanted to add a piece so I quit, ordered the part I wanted and haven’t gotten back to it… So, I’ll be watching closely…
Oz has mentioned the rotary on the fiber is handled very simply…
Good luck
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.