Grayscale Engraving Help

Hi everyone I’m new on here. Been enjoying the software so far but hoping someone can point me in the right direction in terms of an image I need to burn in grayscale. I’m running a 7w jtech laser on my shapeoko xxl and have had a hard time getting the burn/speed settings right. I’m burning the image onto cherry wood. Anyone out there have a similar setup that can lend some insight?

I have the same set up and I am too looking for a cut setting list. Please share if you find something!

This may help: Device and Machine settings for 7W Diode Laser

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.