GRBL Arduino Mega and 0.9.20

I’ve been using 0.9.10 with my Mega GRBL controller. I updated to 0.9.20 and it can no longer connect to the controller. Switching back to 0.9.10 fixed it. Is there something special I need to do with 0.9.20?

Are you running the Mega-V firmware on your board? Two other users have reported issues with that specific hardware / firmware combination.

No, I’m actually using this one -

I believe I finally have this fixed.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.