Hello, i imported alphabet letters in lightburn just after an update (9.24). I started the" A" job and after few seconds the laser stopped with error 25 in the console. i tried several times but it always stop at the same moment. I tried to install 9.23 again but nothing to do. I tried another progr…

Hello, today i tried to import dxf and svg file (the same, A &B) and the machine still stop after few seconds. I tried an old file that worked before and today doesn’t. i’m afraid 9.24 version is not good for me

i installed 9.18 and it’s ok 9.19,ok 9.20,ok 9.21,ok 9.22,ok 9.23, NOK 9.24, NOK

I had same experience at begin. I changed the USB port from back to front port on my PC, the error 2 and error 25 gone.

[image] V0.9.24 error 25 LightBurn Software Questions Are you running GRBL-LPC firmware? If so, I know what this is and it’s fixed already (just found today).

Hello Rick, i’m running GRBL. Do you think it’s the same problem?

Hello, thanks for your answer!, i will try

GRBL error 25 G-code error

LightBurn Hardware Compatibility GRBL

Rick (Technical Evangelist) May 3, 2021, 8:50pm 5