Gweike Cloud thickness setting issue

[Zovi (Vahram Zovighian)]

Hi guys, here we go again

Found probably another bug with Gweike (damn this machine compatibility !!) and it is about the Z adjustment ( DAMN THIS MACHINE’S Z !! ahahahah ):

Everything works fine when engraving from the starting point of an image (so far I haven’t tried with vector, it just happened with image) but if I try to send a job from different point (let’s say middle) from the preview function “start work from here” the Z command doesn’t work at all, I’ve tried with “send to machine” and even by direct Lightburn “start”.

I wish this could help you guys in your awesome constant improvement.

Love ya SO MUCH <3

[Zovi (Vahram Zovighian)]

No Support on this?

[jkwilborn (Jack Wilborn)]

Might want to post the software version you’re using. Help → About Lightburn

I don’t know the Gweike, so I can’t be of much help here but maybe @Rick is up on these and can suggest a proper course to resolve this…

[Rick (Technical Evangelist)]

@Zovi

the preview function “start work from here” the Z command doesn’t work at all

Spoke with Oz about this yesterday, further investigation underway. Thank you for bringing this to our attention.