harleyz
(curt harley)
May 16, 2021, 1:18pm
1
Ive been problem free until all of a sudden im getting my laser jumping nd jittering. this code message comes up after it makes a mess of my project in the middle of it.
Ortur Laser Master 2 Ready!
OLF 140.
Grbl 1.1h [’$’ for help]
[MSG:’$H’|’$X’ to unlock]
error:9
G-code locked out during alarm or jog state.
On or near line 1538:
Job halted
Stream completed in 0:57
Rick
(Technical Evangelist)
May 19, 2021, 7:43pm
2
Yes, that is what that error is about. Have a review of this:
So i can engrave no problem but as soon as i want to up the power and slow down the speed to do cutting with several passes i get this error half way through the job. I have tried different speeds and faster seems better but still wont complete? Tried updated my master 2 firmware and still same issue. Help!! Ruining so much material and its bolted to table!
[SC7A20:(335) Shock and Movement detected!]
Ortur Laser Master 2 Ready!
OLF 140.
Grbl 1.1h [’$’ for help]
[MSG:’$H’|’$X’ to…
system
(system)
Closed
June 18, 2021, 7:43pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.