Help to remove Travel Lines

[debsanders (Debbie Sanders)]

Hi can you please help me to stop the travel lines
thanks

[BrianF84 (Brian)]

Hey Debbie,

try this:

Laser not turning off between cuts? (burning during travel moves)

If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …

Good luck and cheers,
Brian

[debsanders (Debbie Sanders)]

Hi I tried your suggestion No luck Im very new to this .

[BrianF84 (Brian)]

That’s too bad. Have you tried reaching out to Darky Labs?
Is this a new machine and has it done that from the beginning?