I am new to this lightburn, and any other software for that matter. I am learning very slowly. Anyhow, I was able to create a small little project and not have a problem with it. But now, I am trying to create some text, and do it on a piece of wood for a liitle company name sign. and im lost, I can…

Do you have rotary mode enabled? The CanCam machine uses a Ruida controller if I remember right. Go to Tools > Rotary Setup, and make sure the rotary is not enabled - that will mess with the vertical sizes of everything if you aren’t actually using a rotary.

Help with text to wood

Resources Getting Started With LightBurn

Rick (Technical Evangelist) June 9, 2020, 8:49pm 7

This has been resolved in another thread: