Hi I Cannot run sculpfun s9

pick GRBL then table size

1 Like

Can not connect s9. Don’t have device.

Did you load the USB driver?

1 Like

Here is some extensive guides for the S9: Quick Start & Overview - Diode Laser Wiki
Regarding the software setup, I recommend reading Setting up the software - Diode Laser Wiki

1 Like

yes :+1:t2::+1:t2::+1:t2::+1:t2:

Thanks. :pray: :pray:t2::+1:t2::+1:t2:

There’s a great walkthrough of setup for the S9 on LightBurn’s Youtube: Setting Up Your SCULPFUN Laser With LightBurn & First Project - YouTube

1 Like

I added a link to the video to my guide :slight_smile:

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.