Hoatian HT-690 stopped in the middle of a job and rese

Community Laser Talk
, , ,
1

So, my Hoatian HT-690 dual head (100 watts each) stopped in the middle of a job and reset the other day. It will only now travel to where it would normally begin engraving, jerks like it will start engraving, then resets without firing. It pulses fine. Frames fine. It will not engrave or

IMG_2161
IMG_21613024×4032 3.54 MB

cut.
Specs: Lightburn 1.7.03
Controller: Ruida RDC6442G-B
firmware version: RDLC-V8.00.71
computer: HP laptop running Windows 11