How to rehome the laser?

[GrampsCanMakeIt2 (Bob Robinson)]

I have a Creality Falcon 2, with lightburn 2.0.03
I completed a project and began a new one. when I clicked on FRAME the laser went all the way to the right, gave a loud beep and a warning window popped up.
The warning window said:
ALARM : 3
Reset while in motion. Lowt steps are likely. Re-homing is highly recommended.
On or near line 1:

If I click the home button it goes to home.
Other than that, how do I Re-home the laser.
thank you.
Bob Robinson

[Pete.IRL (Peter O D)]

Hi Bob

Check that you are you in ‘Absolute Coordinates’.

You can also Home in the MOVE wndow by using the button at the centre of the direction arrows.

[MikeyH (Mike Hembrey)]

@GrampsCanMakeIt2

Other than that, how do I Re-home the laser.

If you moved the laser by hand, this can occur.There is no mechanism to tell the controller, or Lightburn, you moved it manually.