How to set the program to move across the engraved area?

LightBurn Hardware Compatibility Ruida controllers
1

Hi, Do you know how to set the controller in Lightburn for Ruida to move the whole engraving area from left to right when engraving, instead of doing it letter by letter ? Now it engraves me each letter separately and I don’t know how to switch it to go all over.

2

“Group” your letters, and use “Fill all Groups Together” on that layer.

3

thank you !

1 Like
4

You’re welcome.
(Stumped me once too.)

Jim

5

I switched from RD Works, so I was a little confused :slight_smile: Thank you, sorted and hopefully there will be only satisfaction.

1 Like
6

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.