I am getting a straight line engraved between images towards the end of the engraving

Col0320 · July 13, 2023, 10:36pm

I am getting a straight line engraved between images towards the end of the engravi

ng

berainlb · July 13, 2023, 10:47pm

This is typically caused by not having laser mode enabled in the controller. What is the value of $32 in Edit->Machine Settings? This should be set to a value of 1.

Col0320 · July 13, 2023, 10:49pm

Thanks for the quick response. Yes $32=1

berainlb · July 13, 2023, 10:57pm

Then something else is going on. Can you provide the following:

Run this command in Console and return output:

$$

Draw a simple square in LightBurn. Then go to File->Save gcode, then save with a .txt extension, then upload that file here.

system · August 12, 2023, 10:58pm

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.