Please help my friend set my Mach up for me and I was cutting a board it crashed in to left corner hard sense, then I don’t seam to have the power please help I lost I brand new but learning
By the sounds you just knocked the lens/head out of alignment. You should be able to just realign it and be back to normal
How do I do this sir I brand new any advice is great
OMTech has a surprisingly good collection of setup & maintenance advice in an awkward FAQ format:
Mirror alignment merits an entirely separate article:
Even though the laser head may be knocked askew, it’s worthwhile to verify all the mirrors have good alignment.
If you must realign the laser head to get it perpendicular to the platform, this discussion may be helpful:
Don’t be afraid to dig in with a wrench! 