I know this is a lightburn forum, but with all the great expertise I am hoping someone can put me in the right direction Omteck 50 CP2 laser. [Laser Setup] There wasn’t a hole through the panel for me to run the ethernet cable so I drilled a 1/2’ hole to run it through. I thought I was good and…

Thank you all for your help in diagnosing this problem. This form is the best I’ve ever seen for its accuracy and it’s help. I was able to take the two pieces of fuse out. I could not read them.. I just have cataract surgery yesterday. My neighbor could not read them But my neighbor tried over th…

I did a really dumb thing, laser is dead

LightBurn Hardware Compatibility Ruida controllers

Colin (Colin Worobetz) September 10, 2025, 6:36pm 4

I found an image here:

1 Like