johnvone
(John vonEschenbach)
March 16, 2022, 6:56pm
1
I get a transfer failed message is a problem sending data to the laser machine may be busier pause it says
JohnJohn
(John Johnson)
March 16, 2022, 7:00pm
2
Ortur uses GRBL
You could be on the wrong COM port. Open the Console window and the Laser window and see if the welcome message is in the Console window. If not, try a different COM port (bottom middle) in the Laser window.
This may also help you move forward more effectively.
Folks,
When asking for support for LightBurn via this forum, email or anywhere else, please keep the following tips in mind for the fastest and most helpful answers.
Please provide these details:
What machine do you have?
What controller does it have , and what firmware it is running?
Are you running the latest version of LightBurn?
Is the issue new, or has it happened before? What kind of computer is it, and what Operating System is it running?
Please note these things:
Please speak in co…
system
(system)
Closed
April 15, 2022, 7:00pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.