I Have Laser Yueming CMA 1810 TF how to run LIGHTBURN on it

[Djugurta (DJOUDER)]

Hello Friends …
i Have Laser Yueming CMA 1810 TF how to run LIGHTBURN on it
thank You

[sutick (Steve Utick)]

Are you running SmartCarve now? What generation controller is in it? Maybe post a pic of the control panel for the controller.

[Djugurta (DJOUDER)]

This is a controller of CMA 1810 TF and yes it work with smartcarve

[sutick (Steve Utick)]

Unfortunately, that’s one of their older proprietary controllers that have never been supported by LightBurn that I know of. Their 5th generation controllers are a standard Ruida 6442 controller with custom firmware on them that is supported, but that is not the control panel for the 5th generation controller. So, you’re likely stuck with SmartCarve.

[Djugurta (DJOUDER)]

yes im stucked with SmartCarve … please do u have whatsapp or send me mail on [email removed] for information personel about laser machine

[sutick (Steve Utick)]

If you have questions about the machine, post them here.

[Djugurta (DJOUDER)]

OK my Boy want to buy a lazer machine for working at home …
like this link Lander
he found a machine he want to buy it
so what gendre of machine is best

[sutick (Steve Utick)]

I have absolutely no experience with Diode lasers, so couldn’t make any recommendations. Your best bet would be to post a general message out here in the appropriate forum asking for advice.