Inaccurate cut from Lightburn

[Grey_Area1 (Adrian)]

But, if the Ruida software (RD Works?) does NOT give this problem, then how does that happen? Does Ruida NOT read the values from the machine?

This is the post that mentioned it …

Lightburn origin is "drifting"

Have a problem, that my origin “drifts” when I use lightburn. So I have created a testfile “testpattern.lbrn2” When I run the file from Lightburn I get a 3mm offset, which is visible if I run the file twice. If I do a reset on the laser, the origin returns to the original place. If I upload the file from lightburn to the Ruidacontroller, the same thing happens. Then I tried to export the file as DXF, and import it to RDWorks. Uploaded the file from RDWorks to the controller, and ran it twi…