Hi Ed, So if I have wired this correctly. My set up is as shown in photos.
Green Wire goes from IN on power supply to LPWM1 on controller
Yellow wire goes to WP1 (Water Protect which was same on previous TL-410C controller)
Black Wire L-On1 goes to L on power supply
Blue and White wires are ground wires which i haven’t touched at all on either power supply or controller plugs/terminals. As you can see from original glue on power supply terminal i haven’t altered that at all.
So now the weird thing is if that if I’ve wired it correctly as per your instructions (and my Ruida upgrade manuals as well for that matter). I’ve just tried to cut a square and discovered that it cuts when moving to position and doesn’t cut when it should be like you described if it was connected to H terminal on power supply. So now could it be a problem in either Lightburn or controller settings that have inverted power do you think? Thanks Cleeve