Intermittent "cut doesn't stop when it's done" issue with new 1.7 RC's not seen in 1.6

I sent this to the feedback email, but posting here as well in case others seeing it and can get more data/reports.

With the new RCs running with a Falcon2, I’ve gotten an intermittent symptom where the job finishes the cut, and the head moves back to return position set in LB without any problems seen, but it never actually “finishes” - it stays on Busy. It will continue in that state doing nothing until I choose ‘Stop’. It is not specific to the content as far as I’ve seen, though most of the jobs are relatively small/simple ones.

I don’t recall having ever seen this behavior with 1.6.

I can try capturing more diagnostic information - just let me know what to capture.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.