I’m looking to make a perforation where the hole size is just a single pulse of the laser, so approximately 0.2mm diameter. RDWorks has a point function, but I can’t find an equivalent in LightBurn.
E.g. I want to make a grid 250 x 250 with a 0.4mm gap (X and Y axis) between points…
There isn’t a point function in LB, however you can fake it by using “Cut Through” mode and setting the delay and power for the start of the cut, and 0% power for the rest. Draw an extremely short line and arrange that into your grid.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.