Hello everyone,
I’ve been using lightburn galvo software for a couple of years, and I had an issue after upgrading from 1.6.03 to 1.7.01. In a nutshell, my fiber laser stopped working correctly without any further changes.
It looked like there was a problem with focus. I have off-axis autofocus, and it has worked flawlessly since day one. I downgraded back to 1.6.03, and it is working again.
If it helps, my laser is an enclosed OMTech with a JPT 50w laser source, F=160mm lens, an off-axis autofocus, and an ez-cad lite controller.
Is there a reason why 1.7.01 should not work as expected on this setup?