Issue with laser and table calibration

Having a new problem with my Ortur PM2 with calibrating the sizes. i have done most of the trouble shoot tricks and all the info is correct…

the issue is my laser itself is acting like the table size is MUCH bigger than what’s plugged into Lightburn also noticed it was doing its MAX speed when homing any position home or trying to center it on the image …

we were using the laser last night and noticed center was off when we would place image center than home laser to center of project, we noticed it was to the right a good 2-3 inch

this morning, I checked on the forum for possible issues related nothing I could find. I uninstalled and reinstalled Lightburn and cleaned my laser to insure nothing came unloose. nothing changed.

areas ive checked are the
Machine setting calibrations
i did a pref folder delete
ive uninstalled and installed lightburn
ive hard reset the laser
reset the computer

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.