Seems that when i try to do the alignment wizard LB thinks my laser bed is bigger so it hits the rails every time I try to cut the 1,2,3,4 I never make it past the Frame part of the wizard.

You’ll need to adjust the scale and make sure you’re using “Absolute Coords” mode when doing the alignment, or using the camera for alignment or capture. [image] Tips for calibrating / aligning the camera Resources These are the most common reasons for difficulty with cam…

Issues calibrating LB camera

LightBurn Hardware Compatibility Cameras

JessN (Jess) October 9, 2024, 2:44pm 2

You’ll need to adjust the scale and make sure you’re using “Absolute Coords” mode when doing the alignment, or using the camera for alignment or capture.