I have a very strange issue I hope you all can help with. Not sure if it’s hardware related or software. I recently did she cleaning up of my laser purchasing a drag chain and extending the motor cable and power cable. The laser was working perfectly before I did these changes I needed to clean these wires up because they were getting in the way and ruining my projects. When I finally hooked everything up the laser was not connecting so I had to setup a new laser.
Here is the hard part, explaining the issue, for some reason when using the laser I can’t get it to move left or right unless I move the laser farther up then it starts to move left or right off I start moving it down it will keep moving left or right but as soon as I get to the very bottom it locks up again. The motors act like they are stuck. From what I can see the laser is in the working area. Any ideas what is going on?