Howdy folks I have a k40 with a mini gerbil board to run lightburn. I have been reading all the post I can find on this and have ran some scan test painting the tile white engraving then cleaning the paint off with lacquer thinner. To be honest I’m trying to interpret the results. on some of the patterns of looks like a diagonal line. At 50 mmps and 9 power it looks to be the darkest. Is that what I’m looking for? Also I’m wondering if I should play with my interval. It is at .1mm.
thanks in advance!
Can I provide any more info that would state the question better?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.