Hi
I have a creality 10w falcon that has been working fine. I went to use it but noticed as soon as it is connected the laser was at 100% even when not doing anything.
When I press “Start” and actually want to cut, it actually turns the laser off and then when finished it homes and the laser comes back on?
I do not know of any Lightburn or GRBL parameter that would invert the laser operation.
The only thing I can guess is that you have $30 and $31 backwards. Not even sure if that would do it.
In the Console window, enter $$ to list the GRBL parameters.
Examine $30 and $31 to see if these match:
$30=1000.000
$31=0.000
You made no changes between that time?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.