Laser keeps telling me im out of bound and it cuts wrong

[Caraslasercutting (Carelieze Van Der westhuizen)]

I have cut this file before and now it does that, i had reset lightburn but still does y7us it. Help please

I have a Atomstack-x7-pro

[berainlb (PY)]

Are you overriding the warning that LightBurn provides when you’re getting the bad burns?

If so, I assume you’re not using Absolute Coords in Start From in Laser window. Switch to Absolute Coords and try again.

If this is not the case, please take a full screenshot (not photo) of LightBurn as the job is setup and post here.