I got it to work now now more lines!! I guess when I was looking at settings I seen $32=1 somewheee but when I did the $$ it showed $32=0. Changed it to 1 and now good to go!! Thanks for everyone’s help!!!
1 Like
Sometimes, the firmware settings are protected and won’t survive an on-off power cycle.
With $32=1 set, unplug the power to the laser engraver and disconnect the USB cable. Wait a few minutes and reconnect to your device.
Repeat the request for the $$ report and verify the $32 setting.
Please let us know what you find.
Unplugged everything turned key off turned everything back on hooked up and still shows $32=1.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.